Parker Hannifin, original Patent Holder (US 6851729 B2), for "Tube Fitting, Medium Pressure" developed the MPI Medium Pressure compression fitting connections to be secure and gas-tight while being made manually (wrench turns) or hydraulic set tool. This connection has application throughout industry, including off-shore oil and gas exploration platforms, research labs, and other facilities that require operating pressures to 15,000 psi (1035 bar).

MPI™ Fittings are ideally suited to handle liquids, gases, or chemicals and can be used on a wide variety of tubing materials including: Instrument Grade thick-walled annealed 316 SS, 1/8th Hard (cold drawn) 316 or 317 SS MPI tubing, and 2507 Super Duplex MPI tubing up to 1" OD. Every Parker MPI™ Fitting is supplied complete with both ferrules and compression gland nut, ready to install.

NOTE:

Add to the part number either -SS or -2507 depending on selected material. (Example: 16-16 FBMP7-SS)

Dimensions in inches are for reference only, subject to change.

If produced with the optional thread relief, the minimum boss diameter shall be increased by 1/16”

60,000 psi minimum yield strength required for port material.

ØP is the maximum thru hole. Drill size should be .010" smaller than diameter shown.

All dimensions are in inches unless otherwise specified

Pressure Rating of Fittings is controlled by tubing selected and choice of ASME Standard.

-XF Ferrules are required for 3/4" and 1" 316 SS or 2507 Super Duplex Tubing.